31
A99UE13-1304
1. Carefully read power supply indicated on the specication label of a control box
before using this product. Moreover, conrm the supplied power complies with
product requirement. If there is product damage or personnel injury caused by
wrong supplied power, we will not take responsibility
2. Turn on the power after a controller and an actuator are installed.
3. Because there is a limit of power for transformer built in a controller, please ensure
if the load exceeds the rating output power of a controller before combining with
an actuator. Over rating will result in the reduction of maximum thrust and speed
for an actuator as well as the temperature increase of a controller.
4. Don’t handle this product yourself if faults occur. This product can be repaired by
our qualied technicians only.
5. If the leading connector of a controller is Y type and that is damaged , please
contact manufacturer or product agency to replace it to avoid dangerous.
5.Caution Notice:
4. When the extension tube travels to the end limit, the operation of an actuator will
automatically stop (This function is suitable for LAS1, LAS2, LAS3, LAS4, LAM3,
LAN1, LAN3,LAN3A, LAN5 ,LAC1 and LAC3 series only).
5. For LAM1 and LAN2 series, the operation of an actuator will stop when the
extension tube travels to the external limit. (LAK2LR with a function of controlling
external limit is adopted to cooperate with LAM1 and LAN2 series.)
6. One feature of our controller is to equip over current protector; when an actuator
encounters an unknown obstacle during the operation or stops because of
overload , a controller will automatically stop from the danger. If this situation
repeats many times, please ensure this system is correctly installed and the load
is within the regulation range. If problems still remain, please inform our agent or
distributor.
To Next Page
Loading...
Need help?
General
