Configuration 3-2
© 2005 HMS Industrial Networks AB7607 User manual
Starting the Tool
Launch BWConfig from the BridgeWay Configuration folder in the Windows
Start Menu.
When BWConfig is started, it will attempt to locate an Anybus-X module on one
of the PC serial ports. If a module is found, the status area of the tool will be
updated to show the module type and status of the module that was located.
If a module is not connected to the PC, or is powered off, when the tool is started,
the status area will indicate that no module was detected. Make sure that the mod-
ule is powered and the connection is made, then press the Refresh button on the
BWConfig tool bar; this will cause the tool to rescan the serial ports for a module.
To Next Page
Loading...
