File System 8-8
© 2005 HMS Industrial Networks AB7607 User manual
The contents of this file can be redirected by placing the line ‘[File path]’ on the
first row, and a file path on the second.
Example:
[File path]
\user\eth_settings.cfg
In this example, the settings described above will be loaded from the file
‘user\eth_settings.cfg’.
This permits normal users to access the network configuration settings.
Note: The module needs to be restarted for changes in this file to have affect.
‘ip_accs.cfg’
It is possible to configure which IP addresses and what protocols that are allowed
to connect to the module. This information is stored in the file ‘\ip_accs.cfg’. The
file contains one or several of the headers below.
[Web]
[FTP]
[Telnet]
[Modbus/TCP]
[Ethernet/IP]
[All]
Under each header the allowed IP addresses are written. The wildcard ‘*’ can be
used to allow series of IP addresses. If a protocol header is not given, the system
will use the configuration set under the header ‘All’. If the ‘All’ header is not
given, the protocol will not accept any connections.
To Next Page
Loading...
