BF15D-BF20D
8)
Remove the wires and connectors from the holder of the
starter case
B.
Refer
to
page
2-36
for connector location.
with electric starter).
9)
Disconnect the
SE
thermal valve wire connectors (Type
7)
Disconnect the wire connector from the oil pressure
switch.
[l] CONNECTORS
AND WIRES
VALVE WIRE
'
[l]' OIL PRESSURE
SWITCH
1O)Pull up the starter case
B
slightly and disconnect the
drain tube from the starter case
B.
Remove the
6
x
14
mm flange bolt and throttle cable stay, then disconnect
the linkage pivot of the throttle cable from the carburetor
throttle lever (Tiller handle type).
[l]
THROTTLE CABLE 6x14
[3]
THROTTLE LEVER
8-2
To Next Page
Loading...
