BF15DoBF20D
1)
Clean the parts in the fresh ATF, and blow each port of
the parts with compressed air. Check that the parts are
free from contamination with dust and dirt before
reassembly.
2)
Apply the ATF to a new O-ring, and install it on the valve
B.
3)
Apply the ATF to the valve
B
and install the valve
B
in the
valve body noting the installation direction.
4)
Apply the ATF to a new O-ring, and install it on the
sleeve.
5)
Set the new backup ring on the spool valve and apply the
ATF to the outer surface of the spool valve.
6)
Install the spool valve in the sleeve noting the installation
direction.
7)
Apply the ATF to the sleeve, and install the sleeve in the
valve body noting the installation direction.
8)
Apply the ATF to a new O-ring, and install it on the valve
9)
Apply the ATF to the valve
B
and install it in the spool
10)Apply the ATF to the new O-rings, and install the O-rings
11)Tighten the spool valve cap to the specified torque using
B.
valve cap noting the installation direction.
on the spool valve cap.
the commercially available driver bit
2.8
mm.
TORQUE:
22
N
m
(2.2
kgf
m,
16
Ibf
ft)
[l] VALVEB
[51
O-RING’ 1141
/
..
1.5
x
13.5
mm
BACKUP
//
RING
[3]SPOOL
[I] VALVE
B
[2] SLEEVE
VALVE
VALVEB
SPOOL
VALVE CAP
/
[51 1.5
x
10.7
mm
12-28
To Next Page
