12)Apply the ATF
to
the sealing washer, and set it in the
valve body at right angles. Be careful
not
to
set it
at
an
inclined angle, which can lead
to
the collapsed sealing
washer.
13)Apply the ATF
to
new O-ring and D-ring, and install them
on the manual valve.
14)Tighten the manual valve
to
the specified torque, and set
the internal circlip in the groove in the valve body secure-
TORQUE:
1.7
N
m
(0.17
kgf
m,
1.2
Ibf
ft)
ly.
15)Apply the ATF
to
a new O-ring, and install it on the down
16)Apply the ATF
to
the down relief valve seat and install it
17)lnstall the steel ball, spring guide and the valve spring in
18)Apply the ATF
to
the
two
new O-rings and install the
0-
relief valve seat.
in the valve body
the down relief valve seat.
rings in the valve body in the positions shown.
19)lnstall the gear pump assembly in the valve body by
aligning the projection at the bottom
of
the gear pump
assembly with the positioning hole in the valve body with
care not
to
let the O-rings come out of position in the
valve body
TORQUE:
5
N
m
(0.5
kgf
m,
1.3
Ibf
eft)
20)Tighten the socket bolts
to
the specified torque.
1.2 x 5.8
mm
2.4 x
9.8
mm
[4]
INTERNAL ClRCLlP
I
\'
1.5 x6.5
mm
-
12-29
To Next Page
