BF15DmBF20D
8)
Apply the ATF to a new O-ring, and install it in the lower
groove in the outer tube.
9)
Apply the ATF to the new oil seal. Holding the oil seal
with the fingers
so
that it shapes
"U"
and install it in the
upper groove in the outer tube.
10)Attach a thin sealing tape around the threads at the end
11) Install the cylinder/piston assembly in the outer tube.
of the piston rod.
When it is hard to install the piston rod end in the outer
tube, apply the ATF to the piston rod end, then insert
the piston rod into the outer tube by turning the outer
tube.
Take care not to push the piston rod into the cylinder
with force.
When the piston rod is pushed into the cylinder with
force, push in the free piston in the cylinder as full as it
goes with the threaded part of the piston rod facing
down and by holding the outer tube and cylinder
securely.
12)After installation, remove the sealing tape from the
threads at the end of the piston rod.
2.4
x
12.3
mm
121
Attach a thin sealing tape
around the threads.
\
[l]
OUTER TUBE
/
[31
CYLINDERPISTON
ASSEMBLY
12-32
To Next Page
