BF15DoBF20D
16)
Hold the valve body in a vise as shown taking care not
to
tighten the vise too tight as it damages
the
valve body
17)Tighten the outer tube to the specified torque.
TORQUE:
152 N*m (15.5 kgf-m, 112 Ibf-ft)
POWER TILT MOTOR
/NOTICE]
Do
not reuse the O-ring.
Do
not use a shop towel, cloth, gloves, etc when
reassembly.
5
mm
SCREW
(2)
\
n\
""
\
ARMATURE
Remove the burrs at the
armature shaft with a fine
emery paper before assem-
bly.
Take care not
to
damage
the oil seal during assem-
bly.
[7]
BRUSH
SPRING
(2)
[3]
YOKE
Make sure there is no
metallic part (e.g. washer,
etc.) the magnets before
installation.
After installing the yoke,
lightly tap on the outer sur-
face of the yoke with a plas-
tic hammer (for snug fitting
of the armature bearing).
BRUSH HOLDER
[41
Install with the Iios facina
out (i.e. gear pump assem-
!
bly side).
Replace
1
12-34
To Next Page
