16)Apply the ATF to a new O-ring, and install it on the power
tilt motor assembly.
17)lnstall the oil tank on the power tilt motor assembly
so
that the oil hole cap bolt mounting hole
is
at the motor
wire side.
18)Set the wire band clip on the clip bracket, and secure the
motor wire.
19)Tighten the two socket bolts to the specified torque.
TORQUE: 4.4
N
m
(0.45
kgf
m,
3.3
Ibf
ft)
f.
ATF
FILLING
1) Using a syringe or equivalent tool, add approximately
30
cm3 (1.01
US
oz,
1.06 Imp
oz)
of the ATF slowly through
the oil filler port of the oil tank.
2)
After adding the fluid, tighten the manual valve securely.
Wipe up the spilled ATF thoroughly.
Be sure that the oil hole cap bolt is not tightened.
3)
Connect a fully charged battery, power tilt relay, power tilt
switch and motor
so
that the power tilt assembly can
operate.
4)
To bleed air in the ATF, lean the power tilt assembly to
the left, viewed from the oil filler port side, several times
slowly at an angle of 10" to
30"
as shown.
5)
Push the
"DN"
side of the power tilt switch and compress
the piston rod fully.
6) Using a syringe or equivalent tool, add the ATF slowly
until the fluid
flows
out of the oil filler port of the oil tank.
[2] SOCKET BOLT (2)
-45
kgf
m,
3.31bf.ft))
[3]
OILTANK
[11
CLIP BRACKET
[51
WIRE
PI
11
1
Compress
fully.
Add the ATF
UD
to the
12137
To Next Page
