BF15DoBF20D
7)
Lean the power tilt assembly
to
the side as shown with
the piston rod fully compressed. Push the
"UP"
side of
the power tilt switch and extend the piston rod approxi-
mately
50
mm
(2
in) from the end
of
the piston rod.
8)
With the power tilt assembly inclined
to
the side, add the
ATF to the oil tank slowly until the fluid flows out of the oil
filler port by using
a
syringe or equivalent
tool.
9)
Push the "UP" side of the power tilt switch with the power
tilt assembly inclined to the side, and extend the piston
rod by additional
50
mm from the end
of
the piston rod.
10)With the power tilt assembly inclined to the side, add the
ATF to the oil tank slowly until the fluid flows out of the oil
filler port by using a syringe or equivalent tool.
[l]
Extend approx.
50
mm
from
the fully compressed position.
~~
[l]
Extend by additional
50
mm.
121
Add the ATF up
to
the
edge of the oil filler port.
\\
/
12-38
To Next Page
