16.
ELECTRICAL
EQUIPMENT
I
1.
STARTER CABLE
2
POWER
TILT RELAY
I
1.
STARTER CABLE
Type With
Power
Tilt
a.
REMOVAL
1)
Remove the following:
-
engine cover
(P.
5-1).
-
left engine under cover
(P.
5-3).
2)
Unfasten the wire band, and remove the power tilt relay
wire connectors with the connector holder attached from
the starter case
B.
3)
Disconnect the
1P
connector and remove the connector
from the connector holder.
4)
Remove the fuse holder from the fuse holder bracket.
5)
Pull the starter cable connectors from the holder on the
starter case
B,
and disconnect the white and white/black
wire connectors..
[11
121
STARTER CABLE POWER TILT RELAY
1
P CONNECTOR CONNECTOR
121
STARTER CABLE
STARTER
[
\'
[3] WHITEBLACK
CASE
6
WIRE
16-1
To Next Page
