BF15DoBF20D
b.
INSTALLATION
1)
Install the oil case grommet to the starter cable and align
the inside of the grommet with the white tape on the
starter cable, and install them onto the
oil
case.
2)
Secure the starter cable with the wire band clip and
install the starter cable bracket by aligning the cutout with
the boss on the
oil
case and tighten the
6
x
14
mm flange
bolt securely.
3)
Route the starter cable.
4)
Tighten the ground terminal to the cylinder block using
the
6
x
12
mm flange bolt.
131
STARTER CABLE
BRACKET
[2]
CUTOUT
I
I
16-3
To Next Page
