Honda BF75 - Trim Zero Point Calibration

19
To “Conguring the settings” (P.8)
(8) Trim Limit Reset
You can reset the trim limit position (trim lower limit position).
• Under the following conditions, Trim Limit Reset is grayed
out and cannot be congured.
– When the engine is running
– When the trim tilt angle sensor is defective
– When DLC (dealer's tool) is connected
1. Use the [
∧
] or [
∨
] button to select BOAT SET and press the
[ENTER] button.
2. Use the [
∧
] or [
∨
] button to select Tilt/Trim Preset and
press the [ENTER] button.
3. Use the [
∧
] or [
∨
] button to select Trim Limit Reset and
press the [ENTER] button.
4. Press the [ENTER] button.
• When the Trim Limit Reset setting is successfully
completed, the COMPLETE pop-up window appears.
• If the Trim Limit Reset setting is not completed, the
FAILED pop-up window appears. Retry setting from step 3.
• When the reset is completed, is displayed next to Trim
Limit Reset.