HONDA
CRANKSHAFTIBALANCER
CB40OT
MAIN BEARINGS
I-
Inspect the bearing inserts for damage, separa-
'
tion, or other defects.
Put
a
piece of plastigauge on each journal,
avoiding the oil holes.
.
.
Install the main bearings on the correct
journals, and torque them evenly
in
a cross
3.3-3.7
kg-m
(24-27
lbs-ft)
parttern and in two or more steps.
SPECIFIED TORQUE:
3.3-3.7
kg-m
(24-27 lbs-ft)
NOTE
Do not rotate the crankshaft during
inspection.
Remove the caps and measure the compressed
plastigauge on each journal.
OIL CLEARANCE SERVICE LIMIT:
0.08
mm
(0.003
in.)
Dateof Issue: September,
1977
@
HONDA MOTOR
CO.,
LTD.
To Next Page
Loading...
