Continued
199
uuOperating the Switches Around the Steering WheeluPOWER Button
If any of the doors or the tailgate is opened while the power mode is in ON, a beep
will sound the vehicle and Auto Power OFF guidance will display on the screen.
If you select “YES” the power mode will not change to VEHICLE OFF even if you exit
the vehicle with the key.
u Since Auto Power OFF (including battery power preservation) is not enabled,
make sure to press the power switch when exiting the vehicle.
If you select “NO” or do not select either option, Auto Power OFF will activate when
you exit the vehicle with the key and close the door.
If you leave the vehicle for 30 to 60 minutes with the transmission in
(P and the
power mode in ACCESSORY, the vehicle automatically goes into the mode similar to
VEHICLE OFF (LOCK) to avoid draining the 12-volt battery.
If you open the driver’s door when the power mode is set to ACCESSORY, a warning
beep sounds.
■
Automatic Power Off
■
Power Mode Reminder
1Auto Power ON/OFF
If none of the above situations apply but the power
mode still does not change, refer to the following.
2 Low Keyless Remote Signal Strength P. 174
If the vehicle is not operated while the shift position
is in
(P and the driver’s seat belt is not fastened, the
power mode will change to VEHICLE OFF after some
time.
You can change the Auto Power ON/OFF settings.
2 How to Customize the Vehicle Settings
P. 336
If the vehicle is stopped for a period of time while the
power mode is in ON, a beep will sound and
guidance for preserving battery power will display on
the screen.
If you select “YES” the power mode will stay ON.
If you select “NO” or do not select either option, the
power mode will automatically change to VEHICLE
OFF after 10 or more seconds.
20 2EX JSS (KE KG)-32TYF6000.book 199 ページ ２０２０年３月６日 金曜日 午後６時５８分
To Next Page
Loading...
