TuxedoW Home Automation and Security System User Guide
41
Updating Controllers (Keypads) with New or Removed devices
When devices are added or removed from the Z-Wave network, the device information needs to be updated in the Controllers. To
update this information, you do not have to remove the device first. From the Primary controller, do the following:
ICON ACTION NOTES
1. Press Add on Primary controller.
2. Press
Devices > Setup > More > Learn Mode on
Secondary controller.
The controller scans for device changes.
The message Devices added Successfully is displayed.
Removing a Secondary Controller (Keypad)
To remove the Secondary controller, do the following:
ICON ACTION NOTES
1. At the primary controller keypad, press Delete.
2. At the secondary controller keypad, press Delete.
Both keypads will display Device Remove and the secondary
controller keypad will revert back to primary controller.
Z-Wave Troubleshooting
PROBLEM SOLUTION
Cannot add new
device.
Make sure the Z-Wave device is within range of the TuxedoW touchscreen; you may need to move the
device closer to the keypad. Refer to the Z-Wave device's instructions for the recommended distance.
Device is within proper
range but still is not
enrolled.
1. At the TuxedoW touchscreen:
a. Press the Devices icon from the Home screen and then press the Setup icon to display
the Z-Wave Device Management screen.
b. If the device does not appear on the screen, press the Remove Device icon.
2. At the Z-Wave device, press the Function Key. The screen will display the message
Device Removed.
3. At the TuxedoW Touchscreen, Enroll the device again.
Selected device will
not delete.
When deleting a device, if the selected device remains on the screen, highlight the device
name and press the REMOVE FAILED icon.
To Next Page
Loading...
Need help?
General
