Honeywell 8680i

8680i User Guide 91
not transmitted, and no error tone sounds. If you wish to hear the error tone when a
non-matching bar code is found, scan the Data Format Non-Match Error Tone
On bar code. Default = Data Format Non-Match Error Tone On.
Primary/Alternate Data Formats
You can save up to four data formats, and switch between these formats. Your pri-
mary data format is saved under 0. Your other three formats are saved under 1, 2,
and 3. To set your device to use one of these formats, scan one of the bar codes
below.
Single Scan Data Format Change
You can also switch between data formats for a single scan. The next bar code is
scanned using an alternate data format, then reverts to the format you have
selected above (either Primary, 1, 2, or 3).
* Data Format Non-Match Error
Tone On
Data Format Non-Match
Error Tone Off
Primary Data Format
Data Format 1
Data Format 2
Data Format 3