182 8680i User Guide
MIN2[ACK],
MAX60[ACK],
DFT[ACK].
This response indicates that the device’s Codabar Coding Enable (CBRENA) is set
to 1, or on;
the Start/Stop Character (SSX) is set to 0, or Don’t Transmit;
the Check Character (CK2) is set to 0, or Not Required;
concatenation (CCT) is set to 1, or Enabled;
the Minimum Message Length (MIN) is set to 2 characters;
the Maximum Message Length (MAX) is set to 60 characters;
and the Default setting (DFT) has no value.
Trigger Commands
You can activate and deactivate the 8680i with serial trigger commands. First, the
8680i must be put in Manual Trigger Mode by scanning a Manual Trigger Mode
bar code (page 46), or by sending a serial menu command for triggering (page 47).
Once the 8680i is in serial trigger mode, the trigger is activated and deactivated by
sending the following commands:
Activate: SYN T CR
Deactivate: SYN U CR
The 8680i scans until a bar code has been read, until the deactivate command is
sent, or until the serial time-out has been reached (see "Read Time-Out" on page 3-
47 for a description, and the serial command on page 186).
Reset the Custom Defaults
If you want the custom default settings restored to your 8680i, scan the Activate
Custom Defaults bar code below. This resets the 8680i to the custom default set-
tings. If there are no custom defaults, it resets the 8680i to the factory default set-
tings. Any settings that have not been specified through the custom defaults are
defaulted to the factory default settings.
Note: This bar code also causes both the 8680i and the host to perform a reset and become
unlinked.
The charts on the following pages list the factory default settings for each of the
commands (indicated by an asterisk (*) on the programming pages).
To Next Page
Loading...
