Honeywell 8680i

62 8680i User Guide
edited sequence but, if it cannot, the 8680i transmits all output data to the host
device as is, or formatted according to the partial sequence output format (see
Partial Sequence on page 59).
When the output sequence is Off, the bar code data is output to the host as the
8680i decodes it. Default = Off.
Note: This selection is unavailable when the Multiple Symbols Selection is turned on.
Good Read Tone - Output Sequences
The 8680i may be programmed to either beep or click in response to a good read of
each bar code in an output sequence, or to emit a beep or error tone for a partial
sequence. Default = Good Read Click - Each Code in Sequence
and Error Tone - Par-
tial Sequence Output.
,
Required
On/Not Required
*Off
Good Read Beep - Each
Code in Sequence
* Good Read Click - Each
Code in Sequence
Good Read Beep - Partial
Sequence Output
* Error Tone - Partial
Sequence Output