Honeywell 8680i

8680i User Guide 157
T - Wait for Trigger
Waits for a hardware trigger press before taking the image. This is only available
when using Photo Style (1P).
0T Takes image immediately (default)
1T Waits for a trigger press, then takes the image
L - LED State
Determines if the LEDs should be on or off, and when. Ambient illumination (0L) is
preferred for taking pictures of color documents, such as ID cards. LED State is not
available when using Decoding Style (0P).
0L LEDs off (default)
1L LEDs on
E - Exposure
Exposure is used in Manual Style only (2P), and allows you to set the exposure
time. This is similar to setting a shutter speed on a camera. The exposure time
determines how long the 8680i takes to record an image. On a bright day, exposure
times can be very short because plenty of light is available to help record an image.
At nighttime, exposure time can increase dramatically due to the near absence of
light. Units are 127 microseconds. (Default = 7874)
nE Range: 1 - 7874
Example:
Exposure at 7874E with
fluorescent lighting:
Exposure at 100E with
fluorescent lighting: