Honeywell 900U02-0100 - PC Connection via Designer Software

Revision 10 ControlEdge HC900 Process & Safety Controller User and Installation Manual 143
May 2019
Table 20 – Parts needed to make RS-485 Cable
Part #
Quantity
Description
Belden #9271 (or equivalent),
with 120 ohm resistors (2,000
feet Maximum)
Or
Belden #9182 (or equivalent),
with 150 ohm resistors (4, 000
feet maximum)
Variable
Commercially available communication
cable
1
10-terminal connector (Supplied with the
operator interface)
Phoenix #1840379 (or
equivalent) for C30/C50
Phoenix 1803581 for C75.
1
Connector (3-pin) (Supplied with the
controller CPU module)
047260
1
Ferrite cable clamps (Supplied with the
operator interface)
089037
2
Nylon cable ties
7.4. Connecting the ControlEdge HC900 Controller to a PC with
the Designer Software
To establish communications between the ControlEdge HC900 controller and the Process Control (HC)
Designer configuration software use any of the following methods.
 A. Direct Serial RS-232 connection. See page 142. Direct with RS-485 and RS-485 to USB
converter with supplied instructions.
 B. Modem connection. See page 144.
 C. Direct Ethernet connection. See page 157.
 D. Networked Ethernet connection. See page 158.
These methods are described below.
ATTENTION:
Always observe the wiring/cabling guidelines on page 58.