Honeywell 900U02-0100 - Page 20

Introduction
6 ControlEdge HC900 Process & Safety Controller User and Installation Manual Revision 10
May 2019
Pulse/Freq/Quad (4chan, 1Quad)
900K01-0201
Can be used in Safety systems
on the Process Worksheet ONLY.
Safety Universal Input/ Output
900U02-0100
Yes
Low VoltageTerminal Block (Euro style)
900TEK-0200
Yes
Low VoltageTerminal Block (Barrier style)
900TBK-0200
Yes
High VoltageTerminal Block (Euro style)
900TER-0200
Yes
High VoltageTerminal Block (Barrier style)
900TBR-0200
Yes
High Density Terminal Block (Euro style)
900TCK-0200
Yes
Filler Block Terminal Cover
900TNF-0200
Yes
Analog Input Remote Terminal Panel
(RTP)
900RTA-L001
No
Relay Output Remote Terminal Panel
(RTP)
900RTR-H001
No
DI, DO, AO Remote Terminal Panel
(RTP)
900RTS-0001
No
Power Supplies
120/240 VAC. 60W
900P01-0401
Yes
Redundant Power status module
900PSM-0200
Yes
Redundant Switch module
900RSM-0200
Yes
*Reference only – For the latest Hardware and firmware revision numbers can be found at:
https://www.honeywellprocess.com/library/support/Public/Downloads/ControlEdge HC900-
SafetyControllerModulesRevisions.zip
Conventions
Throughout this guide, where the text “Legacy systems” is used, the following model numbers are
applicable.
 Legacy systems Model Numbers
 900C51 – 00XX-00
 900C52 – 00XX-00
 900C31 – 00XX-00
 900C32 – 00XX-00
 900C71 – 00XX-00
 900C72 – 00XX-00
 900C71R – 0000-XX
 900C72R – 0000-XX
 900RSM – 0001
 900C73R – 0000-XX
 900C53 – 00XX-00
Throughout this guide, where the text “New systems” is used, the following model numbers are
applicable.
Note: Model number change: 900*xx where if *= C designates Controller module and *=S designates