GasAlertMicro 5/PID/IR
User Manual
42
Table 7. Alarms
Note
If enabled, during an alarm condition the Latch (latching
alarms) option causes the low and high gas alarms (audible,
visual, and vibrator) to persist until the alarm is acknowledged
by pressing C and the gas concentration is below the low
alarm setpoint. The peak concentrations display continually
until the alarm condition no longer exists. Local regulations
may require the Latch Alarms option be enabled.
If the Stealth option is enabled, the detector only vibrates
during an alarm; the audible and visual alarms are disabled.
a Caution: If the detector emits a low battery alarm,
charge the lithium battery pack immediately.
Alarms Screen Alarms Screen
Confidence Beep
• One beep, one flash, and one
vibrate every 10 seconds
MMC/SD Fail Alarm
• One beep every 5 seconds
• S flashes
Alarms Screen
Pump Alarm
• Two fast beeps and alternating flashes
• Vibrator alarm activates
•
L and J flash
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
