Honeywell BW GasAlertMicro 5 - Replace the Lamp

GasAlertMicro 5/PID/IR
User Manual
86
Figure 16. Parts of the PID
Replace the Lamp
Replace the lamp when it falls below the acceptable level. Possible
indicators that the lamp requires replacement are as follows:
• The detector will not calibrate.
• The startup self-test fails.
• The ppm levels are incorrect.
To replace the lamp, refer to the illustrations and procedures in the
PID Lamp Cleaning Kit.
If required, contact BW Technologies by Honeywell for more information.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com