Honeywell BW GasAlertMicro 5 - Replacing a Sensor or Sensor Filter

GasAlertMicro 5/PID/IR
User Manual
84
For sensor problems, refer to Troubleshooting. To replace a sensor or sensor filter, refer to Figure 15., Table 21., and
the following procedures 1-7.
Figure 15. Replacing a Sensor or Sensor Filter
Note
Detectors that are configured for 1, 2, 3, or 4 gases may
contain a dummy sensor in one of the four sensor locations.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com