87
GasAlertMicro 5/PID/IR
Maintenance
Replace the Electrode Stack
Replace the electrode stack when it is contaminated. To replace
the electrode stack, refer to Table 22.
, Figure 16., and the following
procedures.
a Caution
Ensure your fingers do not make contact with the
diffusion barrier or the electrodes on the underside of
the stack.
1. Remove the sensor cover.
2. Remove the old electrode stack.
3. Insert the new electrode stack.
4. Replace the sensor cover.
WEEE Battery Directive
Failure to comply with the following battery removal and disposal instruc-
tions may result in battery shorting, battery leakage, and/or other dam-
age. Ensure a qualified technician completes the following procedures.
Removal and Disposal of the Battery Pack
To remove the alkaline batteries, refer to steps #1 to #3 in Replacing the
Alkaline Batteries on page 82.
To remove the lithium battery pack, refer to steps #1 and #2 in
Replacing
the Lithium Battery Pack on page 83.
Dispose of the battery pack according to local laws.
Removal and Disposal of the Coin Cell
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
