3. Firmware Version
The current firmware version installed on the detector displays on the LCD.
4. Startup Message
If enabled and data is entered in Safety Suite Device Configurator (SSDC), a startup
message (25 characters per line) displays or scrolls (depending upon length of message)
on the LCD. If the startup message option is not enabled, it is bypassed during the startup
test.
Refer to See "Device Configuration" on page28 for more information. in User Options.
5. Location Logging
If the Location Logging option is enabled, the detector prompts for a number (1-999) to
be entered that identifies the location (wells, plants, or other areas) where the detector is
being used.
Within 3 seconds, press and continue pressing until the desired number
displays. To scroll rapidly, press and hold .
Note: The site ID number that is entered does not reset when the detector is
deactivated. If required, enter a new site ID when the detector is again activated.
BW MaxXT II 16 User Manual
To Next Page
Loading...
Need help?
General
