Battery Maintenance and Cautions
WARNING
To avoid personal injury and/or property damage, adhere to the following:
l The detector must be deactivated to charge the battery.
l Charge the battery immediately when the detector emits a low battery alarm. Refer to See
"Charging the Battery" on the facing page for more information..
l Charge the battery using the BW MaxXT II or the GasAlertMicroClip charger adapter only.
Do not use any other charger adapters. Failure to adhere to this precaution can lead to
fire and/or explosion.
l Do not calibrate the detector during or immediately after charging the battery.
l Warning: The BW MaxXT II uses a lithium battery (MX-BAT01) that may present a risk of
fire or chemical burn hazard if misused. Do not disassemble, heat above 212° (100°C), or
incinerate.
l Warning: Lithium polymer cells exposed to heat at 266°F (130°C) for 10 minutes can
cause fire and/or explosion.
l If replacing the battery, use only approved lithium polymer cells that are available
through BW Technologies by Honeywell. Use of any other cell can cause fire and/or
explosion. To order and replace the MX-BAT01 lithium battery, refer to See "Replacement
Parts and Accessories" on page102 for more information..
l Replace the battery only in a safe area that is free of hazardous gas.
l Dispose of used lithium cells immediately. Do not disassemble and do not dispose of in
fire. Do not mix with the solid waste stream. Spent batteries must be disposed of by a
qualified recycler or hazardous materials handler.
l Keep lithium cells away from children.
BW MaxXT II 87 User Manual
To Next Page
Loading...
Need help?
General
