WEBs CIPer Model 50 – USER GUIDE
35 31-00198—01
Appendix
USB Driver Installation for Windows 7
1. Insert the A Male connector of the USB cable into an USB interface jack of the PC and
insert the B Male connector into the controller´s USB device interface jack.
RESULT: The Found New Hardware Wizard is enabled in the Windows Task Line.
2. In the Windows Task Line, double-click the icon.
RESULT: The Driver Software Installation message box displays.
3. If no RNDIS/Ethernet Gadget driver was found as indicated by the message ´X No driver
found`, click Change setting… button.
RESULT: The Device Installation Settings dialog box displays.
To Next Page
Loading...
