WEBs CIPer Model 50 – USER GUIDE
7 31-00198—01
For translating the “Warning” and “Welcome” message of the HMI, you can also use the WEBs N4
Lexicon tool, see section “Local language HMI menus – translation” in this bulletin
HMI pin
PIN, PIN-configuration and log-off definition is fully integrated in the Niagara “User Service”. This makes it
secure and allows to re-use the user definitions already in place for the station.
NOTE: It is mandatory to enter a 5-digit (Numeric only) PIN here. For security reasons, there is no
default PIN.
If the PIN is not present, the controller will not function.
To Next Page
Loading...
