Honeywell CIU 888 - CIU 888 and Service Tool Compatibility Matrix; Recommended workflows to commission CIU 888

Introduction
Part No.: 4417584_Rev12 Configuration Manual
CIU 888 1 - 2
$*6
The applicable configuration tools and scenarios to configure CIU 888
are mentioned in the following table.
NOTE: For Ensite pro database See chapter 3.2.4 "Ensite pro database import
option".
1.1.1 CIU 888 and Service Tool Compatibility Matrix
1.2 Recommended workflows to commission CIU 888
This section gives details on how to commission a CIU 888 (both
redundant and non-redundant), and how to update the site configuration
details of an existing CIU 888.
Use Ensite Pro + Migration tool + Web
interface
Use CIU 888 Service Tool
Supported scenarios:
 CIU 880 being replaced by CIU 888,
except 4 plus host ports in redundant
non cross hot standby configuration.
 Earlier units of CIU 888 being
replaced with new units of CIU 888.
Supported scenarios:
 CIU 880 being replaced by CIU 888
with 4 plus host ports in redundant
non cross hot standby configuration
(new configuration).
 New sites being commissioned for
CIU 888.
 CIU880 Migrations through Ensite
Pro database import
CIU 888 Version Service Tool Version
R103.1/R103.2 Service Tool R101.1
R120.1 Service Tool R120.1
R120.2 Service Tool R120.2
R130.1 Service Tool R130.1
R140 Service Tool R140
R150 Service Tool R150
R160 Service Tool R160
R161 Service Tool R161
R162 Service Tool R162
R210 Service Tool R210