Honeywell CIU 888 - Updating Redundant CIU 888 S Configuration

Introduction
Part No.: 4417584_Rev12 Configuration Manual
CIU 888 1 - 6
$*6
1.2.4 Updating Redundant CIU 888s Configuration
FIGURE 1-4 Updating Redundant CIU 888s Configuration
Notes: 1. Steps 3 and 4 are required only when Entis Pro is a host connecting to
CIU 888.
2. Primary CIU 888 & Secondary CIU 888 must be in sync.
3. Entis pro should be shut down before sending the site configuration to
CIU 888.
4. Updates can be sent only to primary CIU 888 and not to secondary CIU
888.