Honeywell CIU 888 - Page 122

Getting Started
Part No.: 4417584_Rev12 Configuration Manual
CIU 888 3 - 92
$*6
3.2.12.4 User defined modbus map - Density Profiles
This section helps the user to configure the Density Profiles Modbus
area in CIU 888.
The configurable Density Profile fields and a brief description on each of
them are given in the following table.
NOTE: The selected list of entities is shown on the right part of the entities tab, this is
referred as ‘Selected entities’ in the below description.
Type Modbus data type of the entity.
Size Number of Modbus registers
Scale Scaling factor
Offset Offset value
Fields Description
Density Profile Absolute
Start address
This indicates the absolute start address of the density
profiles record.
Values are in decimal. Default value is 30000
Configurable when modbus mapping is User Specified.
Density Profile Record
Interval
This indicates the record interval of the density profiles
record.
Values are in decimal. Default value is 320
Configurable when modbus mapping is User Specified.
Properties Description