Design and Function 5
5.5 Available Process Boards
The configuration of the I/O board assignment is variable. In principle, any
I/O board can be inserted into any slot. If there are any kind of technical
limitations – depending on the board type, they are listed in the following
chapters (descriptions individual boards):
6.3 Installation and Conversion of Process Boards (p. 48)
This chapter describes the ways you can change the I/O board
equipment.
6.4 Connection Diagrams (p. 54)
This chapter includes connection diagrams for typical applications.
5.5.1 ExMFE5 Process Board
WARNING!
Risk of explosion
A risk of explosion exists if lines are connected to the
ExMFE5 board while the device is connected to the power
supply!
The transmitter-, pulse- and signal lines are connected only to the
ExMFE5 board if the enCore FC is connected in a voltage-free
manner.
To Next Page
Loading...
