7 Device Configuration and Commissioning
All newly delivered devices are factory-configured so as to support all
available interfaces.
Setting enCore device parameters, i.e. configuring device functions and
adapting the device to the actual measuring point, is done on site using the
enSuite software.
enSuite system requirements and installation
System requirements and details about how to install enSuite are
available in a separate installation guide. The currently valid
version of the file is always located on the enSuite installation CD.
Alternatively you can download the PDF from the Elster Instromet
website from the section Software downloads:
www.elster-instromet.com/en/software-downloads
A gas specialist must be consulted for this procedure. The presence of a
metrology expert is also required when the device is being used within the
scope of legal metrology.
The online help function in enSuite software contains instruc-
tions for operating enSuite as well as a detailed description of its
parameters.
To Next Page
Loading...
