Honeywell FF-SPS4 Series User Manual

22 107063-11 EN FR26 GLO 800 Printed in France
Emission Frequency Selection
IMPROPER PERIMETER DEVICE OPERATION
The emitter and receiver must be set to the same light emission frequency for proper operation.
Failure to comply with these instructions could result in death or serious injury.
The FF-SPS4 Series safety perimeter guarding system has internal switches that are used to
select the emission frequency (F1 or F2) of the infrared modulated light. To avoid crosstalk or
mutual interference when two perimeter guarding systems are close to each other, these
switches need to be set to different frequencies.
Remember, each emitter must be set to the same frequency as its corresponding receiver. If
a receiver receives a signal from two emitters of the same emission frequency, the receiver
remains in an alarm condition permanently. To return to a normal condition, the emission
frequency of the second emitter must be changed; then receiver power must be turned off and
on. All emitter and receiver devices are factory set to the emission frequency F1 or 50 kHz
(see figures 2-8 and 2-9).
Figure 2-8 Receiver Frequency Selection
12
O
N
12
O
N
FSP14
Figure 2-9 Emitter Frequency Selection
OFF OFF
FSP15
Receiver
Switch
location
Switch positions
Switch positions
Indicators status :Indicators status :
Light Off
Light On
Fre
q
uenc
y
F2
(
40 kHz
)
Frequency F1 (50 kHz)
The position of both switches must be
changed, otherwise the equipment
will remain in an alarm condition.
Emitter
Switch
location
Switch position
Switch position
Indicator status :
Indicator status :
Frequency F1 (50 kHz)
Frequency F2 (40 kHz)
Light On
Li
g
ht Off
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.

Honeywell FF-SPS4 Series Specifications

General

Brand	Honeywell
Model	FF-SPS4 Series
Category	Security Sensors
Language	English