Honeywell FF-SPS4 Series - Setting up

36 107063-11 EN FR26 GLO 800 Printed in France
Figure 2-25 FF-MSK1 White Glass Rear Surface Reflective Mirror (for reference only)
Setting up
Using the laser pen for infrared beam alignment
FF-SPS4 single safety beam
The use of the FF-SPZLASER pen is recommended to perform easy and fast beam alignment,
particularly if the scanning distance is greater than 10 meters. The FF-SPS4 equipment
housing is designed to support the laser pen without any additional mechanical adapter. A
location notch located on the top of the housing is designed to support the laser pen which
should be used in conjunction with a target (such as a white sheet of paper) as shown below.
However, in the absence of the laser pen, the notch can be used as a “backsight notch” to
ease alignment operations.
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.