Honeywell FF-SPS4 Series - Device Compliance and Standards

107063-11 EN FR26 GLO 800 Printed in France vi
Single Beam Device Installation and Use
The installation and use of a safety single beam device requires compliance with strict rules.
Correct installation is necessary to ensure safety and must be carried out by personnel
thoroughly familiar with all instructions and the following safety regulations.
Approvals
Only the packaging and the documentation
of FF-SPS4 Series products carry the CE
mark; the CE declaration of conformity is at
the back of this manual
®
CUS
Canadian Standards Association
Standards Compliance (applicable parts of)
Standard Title
ANSI B11.19 Safeguarding when Referenced by the
Other B11 Machine Tool Safety Standards
ANSI/RIA R15.06 Safety Requirements for Industrial Robots
and Robot Systems
UL508 Underwriters Laboratory
IEC1496 PART 1 and 2
EN 61496 PART 1 and 2
International Electrotechnical Commission;
European Normalisation; Safety of
Machinery - Electrosensitive Protective
Equipment
EN 292 Safety of Machinery - Basic Concepts,
General Principles for Design
EN 60204 Safety of Machinery - Electrical Equipment
of Machines
EN 999 Safety of Machinery - Positioning of
Protective Equipment Related to Approach
Speeds of Parts of the Human Body
EN 294 Safety of Machinery - Safety Distances to
Prevent Upper Limbs from Reaching
Danger Zones
EN 811 Safety of Machinery - Safety Distances to
Prevent Lower Limbs from Reaching
Danger Zones
Regulations
OSHA 29 CFR 1910.212 General Requirements for (guarding of) All
Machines
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.