Honeywell Fire-Lite Alarms MS-9050UD

To Next Page

To Previous Page

Programming

78 MS-9050UD PN 52413:C 01/23/08

To change the programming for the displayed module, press the keyboard down arrow key to

view the following Edit Control screens:

Enable/Disable Module

To Enable or Disable the control module, press the 1 key while viewing the Edit Control Screen

#2. Each press of the key will toggle the screen between Enabled Yes and Enabled No. If

Enabled No is selected, the module will not be polled by the control panel, preventing the

module from activating its output devices. The control panel will indicate a system trouble

condition and the Disable LED will turn on if any devices are disabled.

EDIT CONTROL

1=ENABLED YES

2=TYPE CONTROL

3=SILENCEABLE YES

Edit Control Screen #2

EDIT CONTROL

1=WALKTEST YES

2=ZONE ASSIGNMENT

00 ** ** ** **

Edit Control Screen #3

EDIT CONTROL

1=NOUN/ADJECTIVE

2=DESCRIPTION

********************

Edit Control Screen #4

EDIT CONTROL

1=ENABLED

2=TYPE

3=SILENCEABLE

Edit Control Screen #2

Honeywell Fire-Lite Alarms MS-9050UD - Page 78