Configuring Camera Settings
25
• Manual: Drag the slider to change the preferred level of Gamma correction towards higher
contrast or towards the higher luminance for detailed expression for both dark and
lighted areas of an image.
Note
The Gamma curve function is disabled when the WDR feature in
Exposure settings is enabled.
Defog
Check to improve the visibility quality of captured image in poor weather conditions such as
smog, fog, or smoke.
3D Noise Reduction
Drag the slider to adjust the reduction strength (from low to high).
Note
3D Noise Reduction is mostly applied in low-light conditions. In a
low-light condition with fast moving objects, trails of after-images
may occur. You may then select a lower strength level.
Note
All changes made to image settings are directly shown on screen.
To recall the original settings without incorporating the changes,
click Restore. After you completed the settings, click Save.
Exposure
Go to Setup Camera Setup PropertiesExposure.
On this page, you can set the Exposure measurement window, Exposure level, Exposure
mode, Exposure time, Gain control, and Day/Night mode settings.
Two sets of exposure settings are available:
• In Normal Light Mode tab, configure normal situations for image settings.
• In Profile Mode tab, configure special situations for image settings.
• Night Mode: Check Enable to apply these settings at and select this mode to apply
the settings at night.
• Schedule Mode: Check Enable to apply these settings at and select this mode to
apply the settings at a specific period. Enter the time manually in the field.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
