Performance Series IP Camera Software Configuration Guide
60
Configuring Audio Detection
Go to Setup Video Analytics Audio Detection.
Note Only HC30WF5R1 supports this function.
Audio detection, along with video motion detection, is applicable in the following scenarios:
• Detection of activities not covered by camera view, e.g., a loud input by gun shots or
breaking a door/ window.
• A usually noisy environment, such as a factory, suddenly becomes quiet due to a
breakdown of machines.
• A PTZ camera can be directed to turn to a preset point by the occurrence of audio events.
• Dark environments where video motion detection may not function well.
Figure 6-7 Audio Detection
The blue circles indicate where the audio alarms can be triggered when exceeding or falling
below the preset threshold.
Perform the following steps to configure Audio detection:
1. Once the Audio detection window is opened, the current sound input will be interactively
indicated by a fluctuating yellow wave diagram.
2. Drag the Alarm level slider to a preferred location on the left slide bar.
3. Check Enable audio detection and click Save.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
