NVR Configurations | 109
800-18160 - A - 06/2014
Figure 3-54 PTZ Configuration Interface - Remote
Note You must click Save after configuring the settings to save them.
Controlling PTZ Cameras
1. Go to the single window viewing mode.
2. Open the PTZ camera controller by:
• Right-clicking in the window.
•Pressing the FN button on the NVR’s front panel.
•Pressing the Fn button on the remote control.
The PTZ control interface opens.
Figure 3-55 Pan/Tilt/Zoom Control Interface
Click to adjust the Zoom, Focus, and Iris of
the PTZ camera.
Click, then enter a PTZ camera speed.
Click to adjust the PTZ camera’s position.
To Next Page
Loading...