Honeywell HEN04111 - Figure 3-48 Alarm Configuration Interface; Figure 3-49 PTZ Activation Configuration Interface

NVR Configurations | 95
800-18160 - A - 06/2014
Note The system begins the alarm-triggered recording instead of motion
detection-triggered recording if the local alarm and the motion detection event
occur at the same time.
Configuring PTZ Activation
1. Set the video channel, speed dome protocol, and other parameters in the Pan/Tilt/Zoom
configuration interface.
Go to Main Menu
SettingPan/Tilt/Zoom.
2. Select the channel of the current PTZ for viewing in the monitor, then right-click to open
the Pan/Tilt/Zoom menu.
3. Set a tour pattern.
4. Click Select in the Alarm configuration interface.
Figure 3-48 Alarm Configuration Interface
The PTZ Activation configuration interface appears.
Figure 3-49 PTZ Activation Configuration Interface
5. Select the PTZ activation operation from the drop-down menu. Select from Preset Tour or
Pattern, then click OK.