Honeywell HEN04111 - Figure 3-23 General Settings Interface

NVR Configurations | 61
800-18160 - A - 06/2014
Figure 3-23 General Settings Interface
Table 3-8 General Settings
Setting Description
System time Configure the system time.
Date format Select from three formats: YYYY-MM-DD, MM-DD-YYYY, or
DD-MM-YYYY.
Date separation
format
Select from three formats: dot (.), hyphen (-), or slash (/).
Daylight Saving
Time (DST)
Configure the DST time and date.
1. Enable DST, then click Set. The DST interface appears.
2. Configure the Start time and End time by either configuring the
Week setup, as shown above. Or by configuring the date
setup, as shown below.
3. Click OK to save the new settings.