www.honeywell.com/security
96 | Embedded Network Video Recorder User Guide
Configuring Detection Settings
In the Detect configuration interface, you can configure the event detection settings. There are
three types of detection:
• Motion Detection
• Video Loss Detection
• Camera Masking Detection
Note You can not configure a detection region or sensitivity for Video Loss. You can
not configure a detection region for Camera Masking.
Note The Motion Detection icon appears only if the currently viewed channel has an
enabled motion detection alarm.
Note When selecting the event detection region, you can drag the mouse to configure
the motion detection region without clicking the FN button on the NVR’s front
panel. Click OK to save the currently selected region. Right-click the mouse to
exit the current interface.
Click the Detect icon in the Setting interface to open the Detect configuration interface.
Configuring Motion Detection Settings
Select Motion Detection from the Event Type drop-down list.
To Next Page
Loading...