Web Operation | 171
800-18160 - A - 06/2014
Note You need to use the previous IP address in the LAN to log into the device. Go to
the IP address field, which is found in the device’s current device information.
You can access the NVR through this new address.
Configuring DDNS
Use DDNS to connect the various servers so that you can access the system through the server.
1. Go to the corresponding service website to apply for a domain name.
2. Access the system through that domain name.
Note This works even if your IP address has changed.
3. Select DDNS from the drop-down list.
Honeywell DDNS
The Honeywell DDNS function works with a special DDNS server and special Professional
Surveillance Software (PSS).
Click DDNS in the Network configuration interface to open the PPPoE configuration interface.
Table 5-15 DDNS Configuration Options
Configuration Description
DDNS Type Select the DDNS protocol from the drop-down list, then
enable the DDNS function.
Server IP The DDNS server IP address.
Domain Mode The DDNS server port.
Domain Name Your self-defined domain name.
Email Address Server email address.
To Next Page
Loading...