Web Operation | 175
800-18160 - A - 06/2014
Configuring UPnP
UPnP allows you to establish the mapping relationship between the LAN and the public network.
Here you can also add, modify, or remove a UPnP item.
Preparing for UPnP
1. In the Windows OS, click StartControl Panel Add or remove programs.
2. Click Add/Remove Windows Components, and then select Network Services from the
Windows Component Wizard.
3. Click Details, then check Internet Gateway Device Discovery and Control client and
UPnP User Interface. Then click OK to begin the installation.
4. Enable UPnP from the internet. If your UPnP is enabled in the Windows OS, then the NVR
can automatically detect it through the My Network Places.
5. Click UPnP in the Network configuration interface to open the UPnP configuration
interface.
Interval The interval for sending ranges from 0 to 3600 seconds. 0
means that there is no interval.
Note The system will not send an email immediately when
the alarm occurs. When an alarm, motion detection, or
video abnormality triggers an email, the system sends
out the email according to the interval that is specified
here. This function is very useful when there are too
many emails activated by events, which might result in
an overload for the email server.
Health email enable Click to enable the email health check. The NVR sends a test
email to check the network connection.
After enabling Health Enable, you can configure how
frequently the NVR sends out emails to test the network
connection.
Test Click Test to send a test email. A popup message appears to
indicate the state of the network connection.
Table 5-17 Email Configurations
Parameter Description
To Next Page
Loading...