Honeywell HEN04111 - Upgrading the IP Devices (Batch Upgrade)

Honeywell Configuration Tool | 137
800-18160 - A - 06/2014
Note If you do not select a device before clicking Login, you will get a Connection
Error.
Upgrading the IP Devices (Batch Upgrade)
Note For the following, examples of upgrading an IP camera are shown. The
procedures for upgrading an NVR are similar.
1. Open the ConfigTool software if it is not already open.
Figure 4-10 ConfigTool Login
2. Click Upgrade to begin the batch upgrading process.
The Upgrade interface appears.