www.honeywell.com/security
208 | Embedded Network Video Recorder User Guide
Configuring Preview Control Settings
Click Preview Control in the General settings configuration interface to open the Preview
Control settings configuration interface.
Figure 5-73 Preview Control Configuration Interface
If you select View 1, you have to select a Preview Channel.
If you select View 4, you have to select all channels for previewing.
Configuring System Information
Click the Info tab on the Main Menu to open the Info configuration interface.
Address Configure an IP address for the PTZ dome camera. The
default is 1.
Note Your configurations here should match the
configurations on the PTZ dome camera. If not, you will
not be able to control the PTZ dome camera.
Baud Rate Select a Baud Rate for the PTZ dome camera. The default is
9600.
Data Bit Select a Data Bit rate for the PTZ dome camera. This value
should match the setting on the PTZ dome camera. The
default is 8.
Stop Bit Select a Stop Bit rate for the PTZ dome camera. This value
should match the setting on the PTZ dome camera. The
default is 1.
Parity Select a Parity rate for the PTZ dome camera. This value
should match the setting on the PTZ dome camera. The
default is None.
Table 5-28 PTZ Configurations
Configuration Description
To Next Page
Loading...