www.honeywell.com/security
166 | Embedded Network Video Recorder User Guide
Figure 5-28 TCP/IP Configuration Interface
Table 5-12 TCP/IP Configurations
Configuration Description
Mode There are two modes: Static and DHCP.
• The IP address, submask, and gateway is inactive and
not configurable when you select the DHCP mode to
automatically search for the IP address.
•If you select Static mode, then you need to manually
configure the IP address, submask, and gateway.
•If you select DHCP mode, then you can only view the IP
address, submask, and gateway. You can not configure
these values.
• If you switch from the DHCP mode to the static mode,
then you need to reset the IP parameters.
• The IP address, submask, gateway, and DHCP are
read-only values when the PPPoE dial is OK.
MAC Address Displays the MAC address. This field is not configurable.
IP Version Select the IP version, either IPv4 or IPv6.
You can use either version to access the camera’s IP address.
IP Address 1. Use your PC’s keyboard to enter the IP address.
2. Set the Subnet mask and Default gateway.
Preferred DNS Enter the DSN IP address.
Alternate DNS Enter an alternate DSN IP address.
Note For the IPv6 version IP address, the Preferred DNS and Alternate DNS shall be no
more the 128 digits. They also can not be left blank.
LAN Download Enable this function so that the system can process the
downloaded data first. The download speed is 1.5X or 2.0X of
the normal speed.
To Next Page
Loading...